Routine maintenance encompasses basic cleaning and inspections, as well as checks of the spray system to ensure uniform distribution and freedom from blockages. The comprehensive maintenance process for cooling towers is divided into three distinct phases: cleaning and servicing following a shutdown; pre-startup inspection and commissioning; and periodic inspections during normal operation.
Maintenance activities must be executed according to a scheduled cycle, covering tasks such as the lubrication of drive components, cleaning of the heat dissipation system, and cleaning of the water basin. Maintenance of the drive system includes motor replacement and overhaul, adjustment and replacement of reducer belts, replacement of reducer bearings and shaft seals, repair of the reducer's intermediate support housing, replacement and dynamic balancing of the fan assembly, and alignment of the drive shaft. Maintenance of the heat dissipation system involves the cleaning and replacement of water distribution nozzles and fill media, as well as the cleaning of distribution troughs and spray piping; it also includes the replacement and adjustment of automatic spray heads. Traditional manual cleaning methods pose significant safety risks-such as falls from heights, asphyxiation, and slips-and offer limited effectiveness; modern mechanical cleaning methods, conversely, utilize technologies such as high-pressure water jetting and robotic sludge removal. Maintenance of the water basin section includes general cleaning of the basin, leak detection and repair, and the cleaning or replacement of air inlet screens.
Maintenance for Special Operating Conditions
To prevent freezing of the heat exchange components and circulating water, antifreeze agents may be added to the circulating water, or auxiliary electric heaters may be installed within the piping system.